User Tools

Site Tools


opnsensegettingstartedandmaintenance

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
opnsensegettingstartedandmaintenance [2025/11/06 11:59] – [Essential Steps After a Fresh Install] Fabián Rodríguezopnsensegettingstartedandmaintenance [2025/11/07 13:59] (current) – [Essential Steps After a Fresh Install] Fabián Rodríguez
Line 9: Line 9:
     * Define hostname (e.g. `router.home`) and local domain if needed     * Define hostname (e.g. `router.home`) and local domain if needed
  
-  * Go to **System → Settings → Time**: +  * Check for firmware updates (see below under Maintenance)
-    * Enable NTP sync with reliable servers (e.g. `0.ca.pool.ntp.org`)+
  
   * Go to **System → Access → Users**:   * Go to **System → Access → Users**:
-    * Change the password for the `admin` account+    * Change the password for the `root` account
     * Optionally create a new user with limited privileges     * Optionally create a new user with limited privileges
  
-  * Go to **Interfaces → Assignments**: +  * Configure Internet accerss go to **Interfaces → [WAN]**:
-    * Confirm WAN and LAN mappings +
- +
-  * Go to **Interfaces → WAN**:+
     * Configure PPPoE, static IP, or DHCP depending on your ISP     * Configure PPPoE, static IP, or DHCP depending on your ISP
  
-  * Go to **Services → DHCP Server**: +  * Configure your LAN : go to **Services → ISC DHCPv4 [LAN]**: 
-    * Enable DHCP on LAN +    * Check **Enable DHCP server on the LAN interface** 
-    * Configure static leases if needed+    * Configure static leases if needed, by going to the **DHCP Static Mappings for this interface** (click **+**).
  
   * Go to **Services → Unbound DNS → Blocklist**:   * Go to **Services → Unbound DNS → Blocklist**:
-    * Add blocklists (e.g. StevenBlack’s hosts) to filter ads, malware, and adult content +    * Add blocklists under **Type of DNSBL** (e.g. AdGuard List, Steven BlackList) to filter ads, malware, and adult content 
- +    * Whitelist domains 
-  * Go to **Firewall → Rules → LAN**: +    * Enable **Advanced mode** to add custom URLs of Blocklists 
-    * Allow outbound traffic by default + 
-    * Optionally block private IP ranges or sensitive ports +
- +
-  Go to **Firewall → Rules → WAN**: +
-    * Block all unsolicited inbound traffic +
   * Go to **System → Settings → Administration**:   * Go to **System → Settings → Administration**:
     * Enable SSH access if needed     * Enable SSH access if needed
opnsensegettingstartedandmaintenance.1762459157.txt.gz · Last modified: by Fabián Rodríguez